Matthews 5/8" Baby Pin w/ 1/2"-13 Male Thread Car Rigging Used to roll cable side

Used to roll cable side to side on the bottom lip of beam

handheld rigs

to the flat or notched connecting surface

Cast aluminum clamp allowing the addition of a baby (5/8") pin onto any 5/8" rod

Matthews 5/8" Baby Pin w/ 1/2"-13 Male Thread Car Rigging Used to roll cable sideCommonly used with Matthews Telescoping Hangers. Telescoping Hangers have a very substantial pipe clamp to attach to a lighting grid. The pipe clamp has been slightly offset to allow the riser or drop down tube to slide up when there is sufficient room between the grid and the ceiling. It is therefore possible for a 3' Single Extension Hanger to be able to go from a few"es below the grid to the fully extended 3 feet. MSE Telescoping Hangers are